Bring a modern plaza spot to your fingerboard setup.
Inspired by urban promenades, this fingerboard obstacle combines a low, slatted platform with a raised rear ledge. The clean lines and contrasting materials bring a realistic street-inspired look to your miniature skatepark.
TWO MATERIALS. ONE PLAZA.
The wood-look sections are printed with Wood PLA, while the concrete-look body uses Marble PLA. These are 3D-printing materials, not solid timber or cast concrete.
LESS HOLLOW. MORE SUBSTANCE.
Internal infill gives the obstacle a more substantial feel than an empty shell, without claiming a fully solid construction.
Product features
Two different heights for varied fingerboard lines
Raised rear ledge and lower bench-style platform
Wood PLA inserts with a slatted appearance
Marble PLA body for a concrete-inspired finish
Internal infill for a less hollow feel
3D-printed construction with visible surface texture
Dimensions
Raised rear section: 22.5 cm long × 4.5 cm high
Lower platform: 20 cm long × 2.4 cm high
Measurements refer to the individual sections. Width and overall depth are not specified here.
Please note
This is a miniature fingerboard obstacle, not full-size furniture.