Create an urban street spot with this set of four tapered fingerboard bollards from 3DeckGear. Each pillar has angled sides, a flat top and a square base, with a concrete-look finish inspired by street furniture around plazas and skate spots.
Arrange them next to stairs and ledges, mark out gaps or create obstacles to ollie over. The four separate pieces let you adjust the spacing and change your fingerboard park layout between sessions.
DIMENSIONS — EACH PILLAR
• Length: 2.5 cm
• Width: 2.5 cm
• Height: 3.5 cm
MATERIAL & CONSTRUCTION
• 3D printed using PLA Concrete, a plastic printing material with a concrete look
• Internal infill structure supports the outer shell
• Fine layer lines and small surface variations are part of the printed finish
SET UP
Place the pillars on a flat surface. Depending on your setup, removable mounting putty or another suitable fixing may be needed underneath to keep them in position during use.
INCLUDED
• 4 tapered fingerboard pillars