Bring a landscaped street spot to your setup with the Fingerboard Garden Ledge. This 3D printed obstacle combines two wood-look ledge edges, a red brick-look platform and a recessed front garden section.
Practice grinds and slides at two different heights, or build lines across the brick-look platform. The stepped layout adds variety to a compact fingerboard park and pairs well with ramps, stairs and other street obstacles.
DIMENSIONS
• Length: 17 cm
• Width: 11 cm
• Height: 6.5 cm
DESIGN & CONSTRUCTION
• Two ledge levels with wood-look top edges
• Red brick-look platform between the ledges
• Gray concrete-look walls and base
• Recessed garden section at the front
• 3D printed construction with fine layer lines and small surface variations
• Brick, concrete and wood describe the appearance of the printed sections
SET UP
Place the ledge on a flat, stable surface. Non-slip pads or removable mounting putty underneath may help keep it in position during fingerboard sessions.
INCLUDED
• 1 fingerboard garden ledge
Fingerboard, other obstacles and mounting materials are not included.